What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 20.06.2025 03:14
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
so, what happens?
Apple’s Music app in iOS 26 gains my favorite feature from the Mac - 9to5Mac
These devices are installed between the “hot” and “neutral” and protective ground.
There are three different concepts here that are getting confused.
(Dc diagram shown, AC is similar).
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
The bolt then partially travels down the line to your home.
This is 'the assistant's answer'
What is the sum of X+XX+XXX+XXXX?
In schematic diagrams this is the symbol for a fuse:
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
[old diagram got deleted by accident]
Elly De La Cruz throws out Javier Baez with mind-boggling 98 mph throw - New York Post
This is where this question deviates from being a 'generic' question, and becomes more specific.
There are two important concepts here.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Can the Beckham brand survive reports of family feud? - BBC
2024–10–10[John johnson John Johnson ]
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Why do all the stupid people think Donald J. Trump is stupid?
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
but this device (an Inductor) … impedes the rapid changes in the current.
But… the neutral is now “floating” because of the 1 ohm resistance.
Are landlords allowed to make unreasonable requests?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
He then asserts :
[image of Common-mode choke]
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
What would happen if the Earth stopped spinning for one minute?
but I think this circuit , shows a few more pieces.
One is “what exactly is in a ‘surge protector’ ? ”
These are simplified answers to the original question, and does not change anything I wrote above.
What kind of book did you write after turning 55?
The MOV will conduct when the voltage exceeds 50% of line voltage.
What does a fuse do?
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
eight
For this case there are devices called Metal oxide varistors (MOV).
This one hit behind the barn.
Genetic variant tied to doubled dementia risk for older men - The Washington Post
a photo is worth a thousand words.
A fuse is a non-resetable over current circuit protector.
Upvotes:
What do you do when you are struggling to fall asleep?
Barnstars:
But it can get overloaded, and no longer works.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
At one ohm, the resistor has a maximum of 1 watt power.
Here is a simplified AC power diagram.
He then describes Rainy Season and Lightning.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
It seems Mohan does not understand the difference between a comment and an Answer.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
So, the voltage could go up to 500 volts, and the fuse will not open up.
Now when you have a certain ac resistance, then a current flows in a loop.
2024–10–16 [ OO OLAOYE OYEBODE ]
An AC voltage/ current source, and an ac inductive load.
This is where the MOV conducts again, and dissipated the energy.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
One
the problem then depends on "how fast does the fuse operate?".
Edit 2024–10.
The other is “what does a “fuse” do?”
A circuit breaker is similar, but is resettable.
2024–10–14 [Omar Gharbi Omar Gharbi ]
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Because the load is inductive, the current lags the voltage.(by a bit).
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
This device then solves the entire problem.
what exactly is a ‘surge’ protector?
The third is lightning and “how it gets conducted into a home.”
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
First Sentence:
This is the picture of an electronic coil of wire wound around a core of magnetic material.
He then describes the function of a fuse.
At least they know the answer if they wanted it.
nine
What is lightning?
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
It also is a device that limits the change in current flow.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
I post the exact comment here.